This post will outline the steps associated with installing a RJ45 (Cat 5e) Wall Jack using Beldin Wall jack.
Parts List:
Cat 5e or Better Cabling
Belden PS5E BIX DVO Outlet
Nordix Punch-down Tool
Steps:
1. Start with a basic Cat 5E Ethernet Cable
2. Cut cable back approximately .5 inches, which gives you enough room to pull on the thread back.
3. Make a small incision on the shielding which allows you to pull back the thread further. Do not use the associated .5 inches on the end portion of the Belden as you do not know if you accidentally cut the wire.
4. Pull back on the thread, revealing more of the cable up to 2 inches worth.
5. Clip off the shielding and the thread used to cut back the shielding.
6. Open up the container holding the Belden PS5E and separate the faceplate from the Belden Outlet.
7. Pass the cable through the cable management portion on the Belden Outlet, and then begin wiring.
8. The pattern for wiring the Outlet is: w/bl, bl, w/or, or, w/gr, gr, w/br, br and then simply line them up to the Belden punch down. The top set to punch down is associated with the first plug on the left, and the bottom punch down is associated with the plug on the right.
9. Once it has been all punched into the Belden Outlet using the Punch-down Tool and pattern has been verified, simply cut off the excess by using the same tool.
10. Now install the face plate into the wall using two screws provided within the same bag.
Parts List:
Cat 5e or Better Cabling
Belden PS5E BIX DVO Outlet
Nordix Punch-down Tool
Steps:
1. Start with a basic Cat 5E Ethernet Cable
2. Cut cable back approximately .5 inches, which gives you enough room to pull on the thread back.
3. Make a small incision on the shielding which allows you to pull back the thread further. Do not use the associated .5 inches on the end portion of the Belden as you do not know if you accidentally cut the wire.
4. Pull back on the thread, revealing more of the cable up to 2 inches worth.
5. Clip off the shielding and the thread used to cut back the shielding.
6. Open up the container holding the Belden PS5E and separate the faceplate from the Belden Outlet.
7. Pass the cable through the cable management portion on the Belden Outlet, and then begin wiring.
8. The pattern for wiring the Outlet is: w/bl, bl, w/or, or, w/gr, gr, w/br, br and then simply line them up to the Belden punch down. The top set to punch down is associated with the first plug on the left, and the bottom punch down is associated with the plug on the right.
9. Once it has been all punched into the Belden Outlet using the Punch-down Tool and pattern has been verified, simply cut off the excess by using the same tool.
10. Now install the face plate into the wall using two screws provided within the same bag.
Comments
Post a Comment